This series will be open to cars from a variety of Manufacturers listed below. As new models are introduced, they will be evaluated for inclusion into future series.

All cars will be given a preliminary “tech” prior to each race, and the top three cars in each race will be given a thorough “tech’ at race end…….(open for all competitors to view).

Eligible Models

Fly -GB Track “Chevrons

Slot-it - Ferarri 512’s

Sloter - Lola T280 & T290’s’

1/Bodies/Appearance
Cars will compete with original chassis/body combination, including motor pod where applicable.


Bodies may not be lightened

Cars will have all original detail pieces (transmission, rads, wings, etc.)

Lexan interiors/windows will not be allowed.

Wheels/tires must not protrude beyond wheel wells when viewed from above.

All cars must have wheel inserts (stock/Slot-it etc.)

Cars may be painted but must have a minimum of 3 racing numbers and appropriate decaling.

Cars with working lights may have the lights removed, but headlight/taillight covers must remain.

2/ Motors
Please note: 21.5 k motors max are recommended as this track is 75 ft total length with max 10ft straights.

Motors are restricted to 25k, and the same size of motor as original must be used ; S can for S can, Boxer for Boxer etc. ( SCX cars may utilize the Slot-it S can adapter bracket and S can motor.)
Motors must be “unopened”…any evidence of tampering will result in disqualification.

Foil wrappers/Tampo RPM designations must not be removed……any unidentifiable motor will be deemed illegal for the race/series.

Foil wraps may be cut away from the can hole to provide cooling, unless this also removes printed motor specs.

Motor leads may be replaced

Motors may be glued/taped into chassis. Motor sealing tabs must remain visible (uncovered by the glue)


3/ Wheels/Tires

Any Stock Rubber, Silicone, Urethane front or rear tire may be used.

Tires may be glued to wheels.

Any stock/aftermarket wheels (appropriate diameter) may be used

No tire additives will be allowed, and cleaning will be with water only.

(Cleaning tires with anything other than water will ruin the latex track surface, which will eventually REDUCE track grip…..please help keep our/your track clean and fast!!!!!)

Front tires must touch the track at rest on a flat block.

Front tire minimum width 8.0 mil.

No nail polish/varathane etc. coating on front tires



4/ Chassis/Drivetrain
Cars will compete with original chassis/body combination, including motor pod where applicable.
Chassis sides may be slightly sanded to clear the body…..a couple of thou. is all that is necessary (ask if in doubt).
Traction magnet(s) must be removed.

Guide flag may be secured by a single screw/washer…slot-it Wood guide may be used (no “jet” flags).

Motors/ bushings may be glued in place.

Axle spacers may be used.

Weight (lead/brass) may be added to inside of chassis (no weight on underside of chassis).

Gear ratio is “open” (48P/50P gears only)

Minimum track clearance of .047” (all chassis/body/gears). Sidewinder (spur) .040”




Manufacturer Specific (Additional) Modifications


All  cars may be upgraded with brass bushings, axles, set screw wheels, gears.


Al specified  cars with a single piece chassis (ie. no separate motor pod), can incorporate plastic, brass, aluminum reinforcements in the motor box area to alleviate “hop”……these pieces must be added only from the middle of the motor to the axle bushings, and may be attached only using glue.